On Feb 22, 11:44 am, Don Lancaster
> knews4u2c...@ wrote:
>
> > HOW TO?
>
> > As a guide, you need US Patent 4,936,961 ref. figure 1 to 3F.
>
> > If you read something about magical frequencyis, forget that.
> > It works fine with 10KHz or something else if you preferred.
> > Use 50% duty cycle. BUT! the frequency will be doubled in the
> > step up circuit and that's the frequency the Water-Cell will work
> > with. The components must resist at least 2000V.
>
> > The Water-Cell is very simple. Take a lot of stainless steel tubes
> > with the inner diameter of the bigger tube 3mm bigger than the outer
> > diameter of the inner tube. From now you must look at this
> > Water-Cell as a capacitor with water as dilectricum.
>
> > The Water-Cell and the INDUCTOR will resonate at a specific
> > frequency. It's a normal RC-circuit.
>
> > Now the most important: The Water-Cell/Inductor frequency and
> > the doubled frequency from the generator must be exactly the
> > same. A special condition exists in a L/C Circuit, when it is
> > energized at a frequency at which the inductive reactance is equal
> > to the capacitive reactance, XL = XC.
>
> > Adjust the voltage peak level to reach a maximum hydrogen/oxygen
> > producing with a minimum of current using. If you earlier make
> > hydrogen with the electrolysis method with a lot of current,
> > this experiment will really surprise you.
>
> > For even less current you can make some experiment with a
> > centertapped puls-transformer.
>
> This experiment is repeated many thousands of times daily by EIS
> (electrochemical impedance spectrography) researchers. With uniformly
> negative results.
>
> Forever and ever.
>
> Seewww./glib/ a tutorial.
>
> --
> Many thanks,
>
> Don Lancaster
Sorry you are such a miserable failure.
Try again doing it as shown by the poster of the experiment.
You must learn to follow directions Donny.